Priory Polishes have been supplying the Horological clock trade for many years with unique restoration products. If you have a Barometer or Clock Dial in need of restoration and re-silvering we have everything you need in one handy kit. Our Clock Dial Restoration Silvering Kit comes with 50g of Silvering Powder, 50g of Finishing Powder, 100ml of Silver Brass Lacquer and one Stick of Engravers Wax. We do also sell these products separately if you only need to stock up on certain pieces to do the job. Below we will show you how to get your clock face to beautiful condition again.
- The first stage is to remove the distressed old finish and the damaged Silver. Clean the Silver Dial with a process of wet and dry sanding. Use wet and dry sanding paper 400 grit and submerge in water in-between sanding with the paper.
- Continue the above process, clean fully until all the original Silver and marks are removed.
- Use a foam sanding block or fine sanding paper (600 grit) to finish off in the direction of the grain of the metal and rinse. If a ‘spun’ effect is required, put a nail in a piece of old board and rotate the Dial around it while holding fine emery paper on the surface.
- Next you need to re-fill numerals in etched Dials with Black Engravers Wax. You can do this by heating a knife slightly (do not over heat) and melt a small blob of Wax on the tip to drip into the sections. You can also heat the Dial piece being filled slightly. If the old Wax is just cracked, hold the Dial over a heat source to warm the Wax just enough for the cracks to disappear. If the Wax is missing or insufficient, add a few flakes of it to the numerals and heat gently. If you need to cover a large area of engraving, melt over the entire piece and then when the Wax has cooled, use Steel Wool or wet and dry sanding paper to sand off the excess.
- Rub the surface back down again if necessary to be level with the Dial.
- Now you are ready to Silver your Dial. Apply the Silvering Powder onto very slightly dampened cotton wool and apply in a circular motion. Work this into the entire surface of the Dial, a small section at a time. The Silver Powder should be in a creamy consistency and you will need to keep the cotton wool damp the whole time you are applying it. As you apply you will start to see the Silver come through.
- Once you are happy with the colour of your Dial, you need to use the Finishing Powder, rub over again with damp cotton wool and in the direction of the grain of the Dial. Thoroughly rinse off and leave to dry.
- Finally you need to add a light coat of Silver / Brass Lacquer to preserve the finish and stop any oxidisation. The cellulose based Lacquer is fine to use on Clock Dials as long as the first coat is a very quick, light coat. It can then be applied heavier / thicker after the first coat has dried but usually we find one coat is enough. The Lacquer should only be applied thinly to engraved Dials as the Dial Wax will melt and run if too much Lacquer is used. To apply use a soft cotton cloth or a cotton wool pad; a quick swipe is the usual method then leave to dry before touching or attempting to add more Lacquer.
Some side notes –
Cleanliness is of paramount importance when Dial Silvering and almost all problems encountered are due to finger marks on the metal between cleaning and applying the powder. Silvering Powder acts by chemical reaction with the metal, and if this cannot take place evenly, an uneven colouring occurs.
This powder will not work on Plated or Lacquered Dials; it is only designed to clean Brass or Copper and not Aluminium.